Barry,
It's possible to do because the software in DX4WIN does not
disturb the bandwidth setting if jumping to the same mode. However,
WriteLog has the same problem you mention (don't know what BW it goes to,
but certainly wider than the 300-500 Hz I've been using this weekend.
So, there is an existence theorem!
73, Duane
On Sat, 29 May 2004 12:04:54 -0500 "Barry Merrill" <barry@mxg.com>
writes:
> Is there any way to "freeze" the bandwidth?
> When I set BW down to 500, then command the radio to a new
> frequency
> (thru Call window, or thru packet spot)
> ((yes, I'm assisted - I need all the help I can get))
> the BW is always restored to 1070.
>
> And were is that default of 1070 set?
>
> Barry, W5GN
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
--------------------------------------
Duane Calvin, AC5AA
Austin, Texas
http://home.austin.rr.com/ac5aa
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|