The pictorial is right. The un-plugged into pin is the rearmost (to the rear
of the radio) pin outside of 34...the two connectors are tight together.
Chuck KE9UW
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of Joe Simpkins
> Sent: Saturday, September 04, 2004 9:28 AM
> To: tentec@contesting.com
> Subject: [TenTec] OMNI VI+ Logic Board
>
>
> Would there be anyone on this reflector that might help me
> determine a plug
> and pin configuration?
> After removing the 4 screws of the top of this radio, one can see
> the logic
> board on the right hand side of the radio facing you. There is a 6 pin
> header on this logic board that receives connectors labeled 41A and 34.
> Connector labeled 41A is a 3 pin connector and 34 is a 2 pin
> connector. The
> receiving header on the Logic Board is a 6 pin header, thus leaving 1 pin
> unaccounted for. The pictorial in the manual is not clear which
> pin on the
> Logic Board header is NOT connected by either of the 41A or 34
> connectors.
> By the general convention of the other headers and connectors and
> review of
> the pictorial on page 4-19, it would seem that the two connectors
> are tight
> against one another leaving the empty pin outside the connector 34.
> I would not dare apply power to the radio until I am certain of
> the proper
> connection.
>
> This seems to be the only void in the information from the
> manual. The Logic
> Board must be removed to install the TCXO daughterboard from TT.
>
> Thanks for any help!
>
> 73,
>
> Joe K4MD
>
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.745 / Virus Database: 497 - Release Date: 8/27/2004
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|