To: | larrylg1@roamer.net, tentec@contesting.com |
---|---|
Subject: | Re: [TenTec] Coax For Low Power HF |
From: | Ken Brown <ken.d.brown@verizon.net> |
Reply-to: | tentec@contesting.com |
Date: | Wed, 15 Sep 2004 18:52:42 -1000 |
List-post: | <mailto:tentec@contesting.com> |
Currently, I am using a 450 ohm bed antenna. Is that a bed spring antenna, or is "bed" and acronym for something? Can I get by ok with the regular old RG 58 coax on my less than 100 ft runs? Absolutely! I have a SGC SG-235 autotuner, rated at 500 watts, and it has a RG-58 pigtail for the 50 ohm port. Assuming the tuner is doing it's job and the SWR is low, the RG-58 will work fine with 500 watts. RG-58 is much lighter than RG-8 (or RG-213 or similar) and will make your dipoles sag in the middle a lot less, given the same tension on the dipole. I am used to ladder wire and having an amp; On the other hand if you use bigger coax, you will still be able to run higher power, if you decide to later. Bigger stuff generally has lower loss, but for less than 100 foot runs below 30 MHz, you'll probabaly never notice that difference. You may wish you had the bigger stuff if you want to operate with some more power on a band where the system has a higher SWR. There are so many varieties of coax out there. Yes, and many different qualities are labled as RG-58 or RG-8 or RG-213, etc, etc. Before you buy anything, look at what is available. Remove the outer sheath and see how dense or sparse the braid is. Many of the suppliers will give a specification for that, and most will probably send you some sample pieces so you can see for yourself. Also you need to consider the connectors. If you intend to use "regular" solder on PL-259 connectors, make sure the coax can be soldered. There are many versions of coax that have really fantasitic specifications, but require special connectors that may require you to buy a fairly expensive crimping tool to install. You can buy already connectorized cable too, but then do you really want to be unable to fix it if the connector comes off? There are some "RG-8X" styles that may be good ( and no doubt some that are junk ) that are about the size and weight of RG-59, but are 50 ohm and are almost as good (loss and power handling capability) as full sized RG-8. Good luck, have fun. DE N6KB _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] Delta mode switches, John Gabbard |
---|---|
Next by Date: | [TenTec] Remote encoder, Chris Swallow |
Previous by Thread: | [TenTec] Coax For Low Power HF, Larry Greenberg N5BEA |
Next by Thread: | Re: [TenTec] Coax For Low Power HF, Tommy |
Indexes: | [Date] [Thread] [Top] [All Lists] |