TenTec
[Top] [All Lists]

Re: [TenTec] : SUB-RX: TEN TEC - ORION

To: <tentec@contesting.com>
Subject: Re: [TenTec] : SUB-RX: TEN TEC - ORION
From: "Carl Moreschi" <n4py@earthlink.net>
Reply-to: tentec@contesting.com
Date: Sun, 19 Sep 2004 16:38:00 -0400
List-post: <mailto:tentec@contesting.com>
Adriano,

I just tried your example here on 40 meters with my Orion main receiver
antenna and sub-receiver antenna both set to antenna 1.  I am receiving a
signal of S 6 on the main receiver and 5 lines on the sub-receiver.  I have
the pre-amp of the main receiver turned off.  You may have an internal cable
unplugged that goes from the antenna switch board of the Orion to the
sub-receiver front.  I would open up the Orion and take a look.

73,

Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Ascani Adriano" <adrianoascani@virgilio.it>
To: <tentec@contesting.com>
Sent: Sunday, September 19, 2004 2:35 PM
Subject: [TenTec] : SUB-RX: TEN TEC - ORION



 HI ALL
My name is Adriano, im from Italy. If can i would ask you something about
TENTEC ORION 565 AT. I received it first days of august/2004. i try to
explain you wath i have noted not good using it.

In 40 meters- (and not only 40 m)- with Sub RX is impossible to listen weak
CW signals: the signal that i listen good  in MAIN RX- totally desappear
when i switch to Sub RX.: both tuned on the same fequency with same
settings. In Europe we have broadcasts in  7.100 -7.300 Kcs: i tune both the
RX on the same freq - (AM MODE): the analogic S-Meter of Main RX give me a
signal   9 + 40 the same antenna, the same settings, the same frequency ....
the S-Meter of SUB RX  show only  2 o 3 lines  signal (hope someone
understands) and switching the AF encoders (main-sub) alternately , the
reception of the Sub-RX is low and ground noise is higher. I think here is
something does'nt work right in the SUB-RX-, when you assign alternately the
same antenna to main and to sub seems to work with 2 antennas and that of
the Sub RX is less efficient. I repeat, the 2 receivers have same settings.
no troubles with Main RX.

In other bands ( i have the JUPITER too)  that has the same SSB sensitivity
like Sub-rx of Orion:i see (same antenna) tuning a broadcast station :
JUPITER . 9+40 ----------> SUB RX  3 line filled of signal strenght. IS
NORMAL THAT?

My old  KENWOOD TS 430S  give me a strongher reception on same frequencies
with same antenna.- If someone have understood my problem give me some
advice. Next days shall do other tests then shall contact TEN TEC service.
Hope in an answer, for now many thanks.

from IZ6FWF
Ascani Adriano
Italy
(bag your pardon for my schoolastic English!!! HI)
----------------------------------------------------------------------------
----

----------------------------------------------------------------------------
----

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>