Skip, Glad to hear you have solved most, if not all, of your problems. You
went to the right place by calling the President of Ten-Tec, Jack Burchfield ,
and got the necessary advice about what you needed to do. I wish that others
with problems would do this instead of going to E-HAM crying the blues.
See if the contrast is set at about 50%. This should clear up any browning
along the edges. There continues to be a little problem in the upper left
corner of many Orion displays with light browning. This may show up after about
four hours of on time. If the problem is severe, you might need a new display.
Good luck with your new rig! Toby W4CAK
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|