I use the Herc II with a RV Battery and a battery charger - disconnect the
battery charger when I use the Herc - reconnect it when the Herc is not in
use - the charger turns off when the battery is at full charge. Reason I
remove it when the Herc is in use is that it puts a 'buzz' on the signal.
But the deep cycle RV battery does fine in SSB (and I assume CW) service.
Dave
----- Original Message -----
From: "Jim Brown" <jim@audiosystemsgroup.com>
To: "Ten Tec List" <tentec@contesting.com>
Sent: Friday, October 08, 2004 1:48 PM
Subject: [TenTec] WTB Power Supply for Hercules II
I've recently acquired a used Hercules II, but without a power supply. Two
questions.
1) Does anyone have a matching TenTec supply in good condition to sell for
its real value
(as opposed to its "collector's value")? I promise it a good home.
2) if you're a currrent or former Hercules II owner and don't use the
TenTec supply with it,
what supply has you found works well with this amp?
Jim Brown K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|