| To: | <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Hi power Ten Tec ant tuner swr drift? |
| From: | "denton" <denton@oregontrail.net> |
| Reply-to: | tentec@contesting.com |
| Date: | Sun, 14 Nov 2004 10:23:47 -0800 |
| List-post: | <mailto:tentec@contesting.com> |
Got a couple of nice replies right off the bat...should of added more
specifics..
I am running barefoot at 100 watts..no amp in the placeI am not using the internal balun but was using a 4:1 current balun I homebrewed as a remote balun...with 3 feet of rg-213 coax. I have determined that the 4:1 current balun was not accepting power on 80 meters and have replaced it with a homebrew 1:1 balun that I have verified as being good via an antenna analyzer. I will replace the internal balun with something a lot more stouter...----- Original Message ----- From: "Michael Tope" <W4EF@dellroy.com> To: <tentec@contesting.com> Sent: Sunday, November 14, 2004 9:45 AM Subject: Re: [TenTec] Hi power Ten Tec ant tuner swr drift? Are you using the ferrite balun? If so, check its temperature too. The stock balun in the this tuner is very unforgiving. When I built this tuner back in 1985, I smoked the balun almost immediately when I started using an amplifier with it. Mike, W4EF.................... ----- Original Message ----- From: "denton" <denton@oregontrail.net> To: "Tentec Reflector" <tentec@contesting.com> Sent: Sunday, November 14, 2004 8:43 AM Subject: [TenTec] Hi power Ten Tec ant tuner swr drift?Hi all...I have recently purchased an old Ten Tec L network ant tuner..the one thatwas in kit form many years ago.I have noticed that when feeding it to a 22 ft elevated ground plane on 80meters (yeah I know, really a mismatch) via 450 ohm twin lead that the swrwill drift on 80 meters and the 2 kv ceramic caps on the cap switch will getreally hot...Will switching the caps to transmitting micas alliviate the problem?? Bad switch?? 80 meters on this particular antenna apparently is the only band thisoccurs with this transmatch...my 238A does not exhibit this little problem when feeding the same antenna. _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Hi power Ten Tec ant tuner swr drift?, Steve N4LQ |
|---|---|
| Next by Date: | [TenTec] Test-Ignore, Ed Purvis |
| Previous by Thread: | Re: [TenTec] Hi power Ten Tec ant tuner swr drift?, Michael Tope |
| Next by Thread: | Re: [TenTec] Hi power Ten Tec ant tuner swr drift?, Steve N4LQ |
| Indexes: | [Date] [Thread] [Top] [All Lists] |