Hi Tommy and group,
Inrad roofing filter for the Plus is going to be selectable, using
the N1 and/or the N2 button on the front panel. The filter is housed
in the Inrad standard filter enclosure, and the last info I had was
that it will physically be mounted on the 9MHz filter board, with
three coax cables to be attached within the Plus. Think you will also
need to supply +12vdc to it, but knowing George, the installation
should be rather painless!
That sounds interesting. I should have also said in my original post,
that putting it in the Y1 position would require some switching
arrangment, unless turning the rig into a CW (and perhaps digital mode)
only rig is okay.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|