[TenTec] Need Schematic to 962 Power Supply or Part info for bridgerectifier

[Jerry Volpe <kg6tt@tomorrowsweb.com>]

Darn!

This morning my Omni-VI+'s 962 power supply died. Blew its 5amp primary 
fuse. I wasn't even transmitting when this happened... just listening. 
Anyway, I isolated at least part of the problem, I hope the entire 
problem, to a partially shorted bridge rectifier (two of the four diodes 
show total shorts both ways). As I wrote, hopefully this is the entire 
problem and not a secondary issue caused by s short in the regulators. 
Anyway a good place to start.... Except:

I only have schematics to 960 and 961 Power Supplies. I have no idea 
where my 962 manual went to :(
Yes, I know I can get a replacement manual from Ten-Tec and I will order 
one next week, but for now does anyone have the schematic of the 962 
that they can email me? If not can you at least look up in your manual 
and send me any information shown there for this bridge rectifier? A 
manufacture's part number would be a good starting point. Specs would be 
nice... maybe I can buy a part locally. Kinda poor of this to go out 
during vacation week :(

Fortunately I have my Paragon!

Holiday Best Wishes Continues!
Jerald, KG6TT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec