TenTec
[Top] [All Lists]

RE: [TenTec] Orion amp line delay/advance

To: <tentec@contesting.com>
Subject: RE: [TenTec] Orion amp line delay/advance
From: "NJ0IP" <Rick@DJ0IP.de>
Reply-to: tentec@contesting.com
Date: Sun, 26 Dec 2004 16:48:22 -0800
List-post: <mailto:tentec@contesting.com>
"... now applied to the keying loops as well as..."

(I left out the word "loops" in the previous email) - Rick

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of NJ0IP
Sent: Sunday, December 26, 2004 4:45 PM
To: tentec@contesting.com
Subject: RE: [TenTec] Orion amp line delay/advance

Buck,

Hit "MEUNS", "TX" and lines number 5 and 6 are "EXT T/R Delay 1" and "EXT
T/R delay 2".  I have mine set to 22%.  For about 30 wpm, that enables
hearing between words, but not characters.

By the way, this delay is now applied to the keying as well as the single
cable keying (as of the latest firmware release, 1.372).  Prior to this
release it was only applied to the single-line keying, not to the loops.

73
Rick

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of K4IA@aol.com
Sent: Monday, December 27, 2004 8:35 AM
To: tentec@contesting.com
Subject: [TenTec] Orion amp line delay/advance

Just what is the amount of delay (or is it more accurately "advance") on
the 
Orion amp keying line?  
 
Is the factory default safe?  
 
I can't find a place to change it unless the keying loop is enabled and I  
don't have an amp with such a loop.  

Radio  k4ia
"Buck"
Fredericksburg, VA USA

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>