TenTec
[Top] [All Lists]

RE: [TenTec] 252mo PS Question

To: <tentec@contesting.com>
Subject: RE: [TenTec] 252mo PS Question
From: "DaveHeller" <k3tx@fast.net>
Reply-to: tentec@contesting.com
Date: Tue, 18 Jan 2005 23:27:35 -0500
List-post: <mailto:tentec@contesting.com>

-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of Michael, Dana A
Sent: Tuesday, January 18, 2005 12:43 PM
To: 'tentec@contesting.com'
Subject: RE: [TenTec] 252mo PS Question

YES that is correct and there is no adjustment for the voltage. The trim
pot
you see if you take the lid of is for the trip current.

73, Mike W3TS

-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of bharen@bellsouth.net
Sent: Tuesday, January 18, 2005 12:37 PM
To: tentec@contesting.com
Subject: [TenTec] 252mo PS Question


All,

I just got hold of an old 252mo power supply for use with my Omni A.
The
supply has not been used for at least the last 3 years.  It fires up and
puts out 13.07 volts.  Is this the rated output for this supply?  I
don't
have access to a copy of the owners manual so I figured someone on this
group would be able to help out.  TIA!

73,

Brian
W8BYH


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
The manual :  "up to 18 amperes at approximately 13 volts dc, regulated
. ." If you'd like a photo of it (it's short) no problem.  E-mail very
iffy - I'm  as fluent with e-mail as I guess you are with farsi.  QRZ
info is correct;  also ref article by W3ZI on ARRL site.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>