| To: | <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] MODEL 219 Filter |
| From: | "Kip Williams N6NVP" <n6nvp@cox.net> |
| Reply-to: | tentec@contesting.com |
| Date: | Sun, 30 Jan 2005 18:03:38 -0800 |
| List-post: | <mailto:tentec@contesting.com> |
I've been looking at the Model 219 250Hz filter being sold by TenTec. I'm curious if this is compatible (the same, perhaps?) as the 219 that was available for the Argosy 525D? _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] WTB:Working 263 VFO for Corsair, David Patton |
|---|---|
| Next by Date: | [TenTec] WTB: Paragon RS-232 serial interface board, Jerry Volpe |
| Previous by Thread: | [TenTec] WTB:Working 263 VFO for Corsair, David Patton |
| Next by Thread: | Re: [TenTec] MODEL 219 Filter, Steve N4LQ |
| Indexes: | [Date] [Thread] [Top] [All Lists] |