TenTec
[Top] [All Lists]

Re: [TenTec] Orion Power Meter Pegging

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion Power Meter Pegging
From: "Mark Erbaugh" <mark@microenh.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 27 Feb 2005 21:15:29 -0500
List-post: <mailto:tentec@contesting.com>
About 100w (jus a little less than full scale).

Mark

----- Original Message ----- 
From: "Steve Baron - KB3MM" <SteveBaron@StarLinX.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, February 27, 2005 8:01 PM
Subject: Re: [TenTec] Orion Power Meter Pegging


> What did steady state power indicate?
>
> ----- Original Message ----- 
> From: "Mark Erbaugh" <mark@microenh.com>
> To: <tentec@contesting.com>
> Sent: Sunday, February 27, 2005 23:18
> Subject: [TenTec] Orion Power Meter Pegging
>
>
> > I just made my first CW QSO with the Orion where I ran full (100w)
power.
> I
> > noticed that at the beginning of a transmission, the meter would peg as
I
> > could hear it hitting the stop.  It quickly dropped back to 100w. I was
> > transmitting into my triband beam which has a pretty low (< 1.5) SWR.
My
> > rise time was set at 8 ms, I was keying at 16 WPM.
> >
> > 73,
> > Mark
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>
  • Re: [TenTec] Orion Power Meter Pegging, Mark Erbaugh <=