It's tough and it doesnt make much difference. I take off the rubber rings
and loosen up the knob with the hex wrench and push/pull it it or out to set
the drag.
John N1JM
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Able2fly@aol.com
Sent: Thursday, March 10, 2005 6:23 PM
To: tentec@contesting.com
Subject: [TenTec] Omni 6 tuning drag
According to the Omni 6 manual, tuning knob drag (friction) is adjustable
by
holding the chrome knob flange still while rotating the knob itself. What's
the trick to accomplishing that without damage? I don't see any way to grab
the flange.
Thanks, Bill
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|