Will,
Let's start with the basics and check all of the internal cables on the OMNI
6 for a good conection. Re-seat all of the cables and see what happens.
Good luck & 73,
Dave, K2DP, St. Louis
OMNI 6+ here
----- Original Message -----
From: <wlbaber@bellsouth.net>
To: <tentec@contesting.com>
Sent: Sunday, March 13, 2005 7:21 PM
Subject: [TenTec] Omni VI, opt3 problem
> After 7 or 8 years my first difficulty with Omni VI...no signals on 20
> meters but audio, and audio and signals on all other bands. No power
> output on all bands but low-level signal is there. I know it has to go
> back, but wonder if anyone can comment on what may be the problem. I went
> into it to adjust the bfo, which was off a significant amount--couldn't
> quite at the LSB BFO to 9.000 Mhz but close enough. Put covers back on,
> and was in receive when it stopped receiving on 20 meters.
>
> I'll bet I'm no the only one! Thanks.
>
> 73, will, wj9b, dit dit
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|