| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Corsair II Alignment Manual |
| From: | "Stever1k" <stever1k@hotmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 18 Mar 2005 16:56:43 -0600 |
| List-post: | <mailto:tentec@contesting.com> |
I have a Corsair II that I would like to take and align properly but the
insturuction manual seems to leave a lot to be desired in describing how to
do this. Is there a maintanenace manual for the Corsair II or is there a
set of factory instructions which give you all in the information you need
that anyone has seen.
The instructions for setting up the Pass Band tuning is a case in point. It simply tells you to make an adjustment until both sidebands sound the same or some such thing which is a bit vague for those who's hearing is not real sharp. STeve----- Original Message ----- From: "Tom Sessions" <RADIO_K4RV@peoplepc.com> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> Sent: Friday, March 18, 2005 3:14 PM Subject: Re: [TenTec] boat anchor transverter Oh, horrors! What have I done?!?!? I apologize to your Triton. Only the SuCommKen's with the cheap steel chasses of the same era should be legitimately dubbed (and used) as boat anchors!----- Original Message ----- From: "Larry Laflamme" <laflamme@ncia.net>.To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> Sent: Friday, March 18, 2005 13:46 Subject: Re: [TenTec] boat anchor transverterOMIGOD! You referred to my beloved little Triton as a "Boat anchor" (HIHI)...or is that a term of respect?----- Original Message ----- From: "Tom Sessions" <RADIO_K4RV@peoplepc.com>Subject: [TenTec] boat anchor transverter > I would like to use my 544 on the warc bands. _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec_______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Filters, Ed Malmgren |
|---|---|
| Next by Date: | Re: [TenTec] Filters, Steve Baron - KB3MM |
| Previous by Thread: | Re: [TenTec] boat anchor transverter, Tom Sessions |
| Next by Thread: | Re: [TenTec] boat anchor transverter, Mark Choate |
| Indexes: | [Date] [Thread] [Top] [All Lists] |