Wow, I couldn't even see the connector orientation in my printed
manual. Zooming in on the PDF does show it is oriented the opposite of
the way my Orion is oriented.
So....looks like the drawing needs to be fixed. It would be nice if the
manual included a close up of the power connector.
73,
Alan N5NA
Grant Youngman wrote:
>Either my Orion is not assembled correctly, meaning the chassis
>connector was installed upside down, or the diagram as shown on page
>25 of the Rev. 3 manual is incorrect. It shows the flat sides of the
>connector closest to the cabinet edge when in fact they are oriented the
>opposite direction (in my Orion at least). + power is on the top as shown.
>
>"Trust, but verify" is the operative phrase here :-)
>
>-------------------------------
>Grant Youngman /NQ5T
>http://www.globeking.com
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|