TenTec
[Top] [All Lists]

Re: [TenTec] Color for the Orion sreen

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Color for the Orion sreen
From: "Martin, AA6E" <martin.ewing@gmail.com>
Reply-to: "Martin, AA6E" <martin.ewing@gmail.com>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 3 May 2005 15:40:03 -0400
List-post: <mailto:tentec@contesting.com>
This sounds like fun, but putting a colored filter can't improve the
brightness and probably won't improve the contrast.  It will also blur
the image to some extent.

You might get more help with either a circularly polarizing filter or
a wire mesh "collimator" type filter.  These are sometimes used on
displays to enhance contrast by suppressing reflections.  The wire
mesh can be dramatic, but it will limit your off-axis view.  Something
like that is necessary if you want to operate in direct sunlight.

<reminisce>I remember some B&W TV sets in the 50s dressed up with
color filters - blue on top and green along the bottom - to give an
illusion of color.  Right up there with "Halovision"! </reminisce>

I agree that the Orion LCD, though functional, is not all that it
could be, especially compared with my computer monitor or PDA.

73 Martin AA6E

On 5/3/05, Randy K4QO <k4qo@earthlink.net> wrote:
> Folks,
> 
> I'm new to this reflector and I apologise if this has been
> covered.
> 
> I was a bit dissappointed in the murky display on the
> Orion - its not as crisp as the ads show.  Beyond that the
> radio is pretty much a masterpiece with plenty of potential!
> 
> I have used colored Gels for different projects and I
> wondered if using a particular color would help with the
> contrast a bit.  Gels are used on stage lights to color the
> light for effects.  They are available at a production
> supply store for about $5 a sheet.  One sheet will do
> several Orion size screens.
> 
> One gel color that makes the display have about the same
> golden hue as the meter is Apollo AP7500 (Burnt Orange)  It
> looks quite red but the combination of the blueish light
> source in the Orion offsets the color a bit.  The contrast
> is quite good on both normal and reversed screens as the
> color seems to filter out the blue a bit.  They stay in
> place mostly from air pressure.  No need to do anything but
> cut it to the right size and carefully put it in place,
> tucking the edge past the bezel.  To remove them is easier -
> a small piece of masking tape placed on the center and
> slowly pulling will make it just pop out.  Pull fast and the
> tape just comes off instead. (think air pressure)
> 
> I have played with other colors such as blue and green, but
> the gold color has stood the test of time.
> 
> 73,
> Randy
> K4QO
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


-- 
martin.ewing@gmail.com
http://blog.aa6e.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>