TenTec
[Top] [All Lists]

Re: [TenTec] Burned at the bay

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Burned at the bay
From: "Richard Cardwell" <richardcardwell@adelphia.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 20 May 2005 22:26:26 -0400
List-post: <mailto:tentec@contesting.com>
Jim

We seem to be two "rich"'s a K5SF and me - AA2BY. Oh well, as long as I get 
into the group.

Rich

----- Original Message ----- 
From: "Jim Lowman" <jmlowman@sbcglobal.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, May 20, 2005 10:03 PM
Subject: Re: [TenTec] Burned at the bay


> Hi Rich,
>
> It was the reference to "EB" in this message that got you moderated.
> ANY reference to an auction
> or auction site is strictly prohibited on this list.
>
> That being said, I'll remove the moderation.
>
> 73 de Jim - AD6CW
>
> Richard Detweiler wrote:
>
>>Hi Danial,
>>
>>I was out of Ham Radio for several years, When I got back in, I was
>>fortunate when I bought the two omni D's as I knew they were not in great
>>shape from the seller, paid $400 for the both and he threw in a broken 
>>252M
>>for free, they had all the filters and both had two Extra WARC kits in.
>>
>>It took a couple of months of puttering on them, but basicly the antenna
>>diodes and the rf amplifier on both were bad, fixed them and some odds and
>>end connectors.  The contacts on all those band switches needed cleaning,
>>the board connectors were all cleaned, The PTO's weren't difficult either,
>>just alot of careful attention as the face plates as they were removed to
>>get to all the mechanisms,  I used some new felt to replace the old ones 
>>and
>>found some grease that would not seiz up to finish it off.  To fix the
>>On-Off audio control, TT doen't have parts, but found a similar control in
>>100 ohms, so took the original graphite plate out of the one in the unit
>>wiped it up and replaced it with the one in the new control to give it the
>>proper resistance.
>>
>>Things can be done to 40 year old rigs to make them perform like new if 
>>you
>>are creative.  Both came alive and worked very nicely,  Sold them both to
>>new hams on "EB", one in GA and one in AZ,  both were happy with them and
>>reported back to me that they were impressed by the low noise of the OMNI 
>>D.
>>
>>Got serious about contesting and went on to TT's new rigs primairily 
>>because
>>of the impressions from the OMNI D's.
>>
>>Best wishes,
>>Rich
>>K5SF
>>
>>
>>_______________________________________________
>>TenTec mailing list
>>TenTec@contesting.com
>>http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>