Ok but I doubt all of this. The Orion I had here was totally devistated
by BCI from WHAS, 50kw about 10 miles away when using my loop. The loop
gives any rig a hard way to go unless there's a tuner inline. A few rigs
are able to withstand this such as my TS-480, TS-930, IC-756PROII and
OMNI VI but the older TT rigs were totally rendered useless unless I had
a tuner or my ICE filter in-line. Oh yes, the Jupiter and Pegasus were
also wiped out. The Orion was blasted on 160 and 80m. My HQ-150 and SX-
122 don't notice a thing! '
Steve
-----Original Message-----
From: "Stuart Rohre" <rohre@arlut.utexas.edu>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Date: Fri, 27 May 2005 14:35:10 -0500
Subject: Re: [TenTec] ORION BCI
> Although rare, diodes could exhibit other effects than open or short or
> normal. It might NOT show up with barrier voltage test of diode
> section of
> DMM but might show up if you view the circuit signals with a scope.
> Depends
> on how the protective diodes are configured, whether they are in series
> with
> a resistor. And it might not be the internal diode connection, but
> the
> external solder joint, in fact; much more likely. One could shotgun
> the
> solder by reheating joints, if magnifier inspection shows any suspect
> joints.
> Heat sink the lead at the diode body for protection of it. This indeed
> might be what happened, someone did not have the assembly correct with
> heat
> sinking.
>
> The resistors need to be checked as well, if present.
> -Stuart
> K5KVH
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|