TenTec
[Top] [All Lists]

Re: [TenTec] ORION BCI

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] ORION BCI
From: wq7x@cox.net
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 05 May 2005 13:17:20 +0100
List-post: <mailto:tentec@contesting.com>
OTHERS REPORTED THE SAME PROBLEM. SIMPLE ANSWER AND TO THE POINT. Mark wq7x

At 09:26 PM 5/27/2005, you wrote:
>If the diodes are reverse biased, then it sounds to me
>like you lost bias.  Could be nothing more than a
>loose plug on the board.  Why do you presume the
>problem is a design flaw and not just a glitch in your
>radio?  If your TS-930 developed a cold joint that
>began acting as a diode would you then say Kenwood
>made a design error?
>
>73  W9OY
>
>__________________________________________________
>Do You Yahoo!?
>Tired of spam?  Yahoo! Mail has the best spam protection around
>http://mail.yahoo.com
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>