TenTec
[Top] [All Lists]

[TenTec] Orion and ALS-600

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: [TenTec] Orion and ALS-600
From: "Jim" <pywacker@fuse.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 22 Jun 2005 19:36:54 -0400
List-post: <mailto:tentec@contesting.com>
Bob, same here. Works fine. I keep the power set to 90 watts to drive the
ALS-600.

73 de KE4WY Jim

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Bruce Small
Sent: Wednesday, June 22, 2005 7:15 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Orion and ALS-600

Hi, Bob.

I have been using the Orion and ALS-600 combination for a bit over a year.
The only frustration is that the amplifier has a nice ALC function but 
the Orion doesn't seem to have a way to take advantage of it. But then, 
if you are operating CW you will turn it off anyway.
I would say just watch your power so as not to overdrive the amplifier, 
and have fun.

Contact me if you have any specific questions.

73,
Bruce KM2L

Bob Cunnings wrote:

>Hi,
>
>Anyone here using an Orion with an Ameritron ALS-600 amp? If so, are there
>any gotchas with that particular transceiver/amp pairing? (I'm a cw
>operator.)
>
>Thanks,
>
>Bob NW8L
>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>  
>

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>