TenTec
[Top] [All Lists]

Re: [TenTec] Remoting TT auto tuner

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Remoting TT auto tuner
From: "denton" <denton@oregontrail.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 31 Jul 2005 09:26:56 -0700
List-post: <mailto:tentec@contesting.com>
Good morning Scott....getting nice and toasty hr in Pendleton Or...
Well, in the past I have fed my loop kinda upside down from the way you 
did...at 40' at the top with 450 ohm twin lead and open up the bottom with 
whatever was handy for use on 160...
Worked very nicely on 80 and 40 and so-so on 160.
Will have to check out the Wireman on those switches..have been looking for 
them.
the qth for the loop is on the S side of the house, with the shack on the N 
side....
----- Original Message ----- 
From: "Scott / W4PJ" <w4pj@bellsouth.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, July 31, 2005 9:09 AM
Subject: Re: [TenTec] Remoting TT auto tuner


>I have two #10-24 stainless threaded rods going through the concrete block
> wall in my shack near the ceiling.  They are insulated on both sides of 
> the
> wall with ceramic insulators.  I use the manual version of TT's 2KW tuner
> and run 450 ohm ladderline from the balanced output from the tuner 
> straight
> up to the feed-thru's and on the outside of the wall I continue the same 
> 450
> ohm stuff to whatever antenna I am playing with at the time.  I got one of
> those dual knife switches from The Wireman, and mounted it on the wall 
> just
> below the feed-thru's so I can disconnect when we get our usual
> thunderstorms here in South Florida.
>
> I mostly use it for a full-size 80m loop fed in the lower corner.
> [Triangular delta-loop Apex up at 60ft near the top of the tower with a
> tribander on top and a 40m rotating dipole 10 ft above that] That antenna 
> is
> a monster on 75 and 80.  Nab the DX usually 1st or 2nd call.  Can tune for
> any band except 160m, so for 160m I put a SPST n.c. relay to open the loop
> at the mid-point.  Then it becomes a folded diploe and will load ok using
> the tuner.  I admit it's a very compromised antenna for top band, but 
> works.
> Not bad for limited real estate one-tower setup.
>
> Peace
> Scott / W4PJ
> As Tommy WD4K wrote, I'm the "other" Scott, not the "nice" one.
>
> ----- Original Message ----- 
> From: "denton"
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Sunday, July 31, 2005 10:29 AM
> Subject: [TenTec] Remoting TT auto tuner
>
>
>> I will be procuring the high powered TT auto tuner in the near future, 
>> and
>> am thinking of feeding an 80 meter loop at the bottom with it in a remote
>> location, with the tuner located inside the house with a couple of thru
>> insulators going thru the wall of the house to the bottom of the loop.
>> Wonder if anyone has done this before...thanks in advance.
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>