TenTec
[Top] [All Lists]

Re: [TenTec] Paragon Problem Solving Info Needed

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Paragon Problem Solving Info Needed
From: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 04 Aug 2005 08:06:42 -0500
List-post: <mailto:tentec@contesting.com>
Problem solved.  Bad 1N914 diode on the Logic board not allowing ROM access 
for the transition from TX to RX.

73
Bob, K4TAX


----- Original Message ----- 
From: "Robert & Linda McGraw K4TAX" <RMcGraw@Blomand.Net>
To: "Tentec" <tentec@contesting.com>
Sent: Saturday, July 30, 2005 6:43 AM
Subject: [TenTec] Paragon Problem Solving Info Needed


> With all the good technical folks here on the list I take the opportunity 
> to get advice on resolving a problem with my old Paragon.
>
> Symptoms are:
> Receive on all bands and all modes is confirmed as OK.
> Press tune and it appears to switch modes, receiver mutes but after about 
> 3 secs, S-meter appears to indicate signals from the input.  And there is 
> no RF output while in tune regardless of the RF Power setting.  Pressing 
> tune again does not return the unit to receive.  However, pressing LSB or 
> USB does switch back to receive or changing the tuning knob will cause it 
> to revert back to receive.   In transmit, via either PTT or VOX, there is 
> no output when audio applied to the mike input however the unit does 
> appear to switch into transmit, stays muted, but again after about 3 secs 
> the S-meter indicates signals.  Again, releasing the PTT does not return 
> the unit to receive but pressing  the LSB or USB (and maybe other buttons) 
> will revert the unit to receive.
>
> This unit has been sitting on the shelf for some time and has worked 
> flawlessly on a regular basis.  Power supply is 13.8V and stable.
>
> Looks like something perhaps on the logic/processor board has gone west. 
> I haven't poked around inside thus thought I'd asked in the event someone 
> else has experienced the same or like problem.  Any suggestions will be 
> appreciated.
>
> Thanks in advance.   Respond to the list or privately.  Either works for 
> me.
>
> 73
> Bob, K4TAX
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>