It works the same with the Orion. Just plug the "Y" into the serial
connector on the Orion and set the SteppIR control box for Orion. Been
working here with all the radio software that I have just fine.
73, Tom, W7QF
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of CATFISHTWO@aol.com
> Sent: Wednesday, August 10, 2005 00:01
> To: tentec@contesting.com
> Subject: [TenTec] setting up orion to 3 ele steppir
>
> I want to use the auto switch on the steppir with the orion,
> what type of ccable is used, has any one done this, where do
> you get the cable, how well does it work, I am currently
> using it with the 756 and it works fine, using a C-IV cable
> and a Y.. thanks tom N6AJR
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|