Sorry about the typo, the reference is U10 in both cases.
Bob
----- Original Message -----
From: "Robert & Linda McGraw K4TAX" <RMcGraw@Blomand.Net>
To: "Luca" <ik5tsw@virgilio.it>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Thursday, September 08, 2005 3:32 PM
Subject: Re: [TenTec] paragon audio noise in trasmission
> Luca:
>
> Check to see that you are getting a mute voltage transition at connector
> 44
> pin 2 on the IF/AF board. If so then most likely Q12 has failed or D9 is
> shorted thus not allowing muting of the audio output stage U10. Input
> audio to U1 is supplied via pin 3 of connector 55 and is muted by Q12
> conducting to ground.
>
> Before you dig too deep be sure all the connectors are well seated. It
> wouldn't hurt to carefully unplug connector 44, 48, 55 and 50 and then
> reconnect just in case there is a dirty contact on the mute or ground
> lines
> to the AF/IF board. The current levels are very low in this circuit and
> thus not enough voltage to create a "punch" through on an oxidized
> connector.
>
> 73
> Bob, K4TAX
>
>
> ----- Original Message -----
> From: "Luca" <ik5tsw@virgilio.it>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Thursday, September 08, 2005 2:47 PM
> Subject: [TenTec] paragon audio noise in trasmission
>
>
>>
>> Luca wrote:
>>
>>> Hi to All
>>>
>>> I am new member of this very intresting mail list .
>>> I have purchase second hand Paragon 585
>>> When trasmitting i have the distorted audio in a speaker ,is a truble ?
>>> Or is normal ?
>>> You have a possible remedy ?
>>>
>>> Sure of your intresting many thanks in anvance
>>>
>>> 73 Luca
>>> _______________________________________________
>>
>>
>>
>>
>> Luca:
>>
>> Just turn down the monitor control on the back panel. This is a voice
>> sidetone for checking the speech processor, but it isn't particularly
>> useful.
>>
>>
>> 73,
>>
>> Bob WB2VUF
>>
>>
>>
>>
>>
>> Make sure that the MONITOR level control on the rear panel is turned
>> down.
>>
>> 73
>> Bob, K4TAX
>>
>> Luca wrote:
>>
>> Many thanks to all for your answer
>>
>> In my Paragon the MONITOR LEVEL , AF GAIN , RF GAIN ore in max
>> counter-clockwise ad i use the dummy load
>>
>> The problem to decrease if i turned down the RF POWER ad increase in
>> lower band
>>
>> I think the RF retur
>>
>> Many thanks in advance
>>
>> Luca ik5tsw@virgilio.it
>>
>>
>>> _______________________________________________
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|