TenTec
[Top] [All Lists]

Re: [TenTec] open wire feed line

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] open wire feed line
From: "Scott / W4PJ" <w4pj@bellsouth.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 30 Sep 2005 16:19:05 -0400
List-post: <mailto:tentec@contesting.com>
Google is your friend.
"ladderline"
&  "ladder line"
produced these hits.

http://www.wavehunter.com/wire1.htm
http://www.davisrf.com/ham1/ladder.htm
http://www.dxengineering.com/Products.asp?ID=170&SecID=83&DeptID=21
http://www.mfjenterprises.com/products.php?prodid=MFJ-18H250
http://radioworks.com/cwireladr.html
http://www.wsplc.com/acatalog/Radio_Works.html
http://www.universal-radio.com/catalog/cable/3028.html
http://packetradio.com/wire_cable.htm
http://www.radiobooks.com/products/ll4510.htm
http://www.halted.com/ccp16872-wire--450-ohm-ladder-line-500--spool-1318-0500-wir042.htm
http://www.radio-ware.com/products/ll4510.htm
http://users.erols.com/rfc/balncd.htm
http://www.qsradio.com/HFAntennas.htm
http://www.coaxman.com/listitems.php?list=ladderline&pagenumber=1
http://www.hamradio.com/cgi-bin/uncgi/ase?MAN=Van+Gorden
and here is the wireman page:  http://www.thewireman.com/balance.html
and probably more but I stopped scrolling.

One of these above sites should have what you are looking for.

Of course, the plastic coated stuff is not true "open wire feed line"
The only place I found for true open wire feed line is here:
http://www.w7fg.com/ant.htm


PEACE
Scott
As Tommy WD4K wrote, I'm the "other" Scott, not the "nice" one.

----- Original Message ----- 
From: "Ron Zond" <k3miy@csonline.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, September 30, 2005 1:39 PM
Subject: Re: [TenTec] open wire feed line


> Hi Paul
>
> AES should crry what yoiu are looking for
>
> Ron
> K3MIY
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of Paul DeWitte K9OT
> Sent: Friday, September 30, 2005 1:20 PM
> To: tentec@contesting.com
> Subject: [TenTec] open wire feed line
>
>
> I would like to purchase some of the plastic windowed twin lead feedline.
I
> do not find many sources.
> The wireman was the only one that I saw that handled it.  Are there many
> sources? Or is it mostly a thing of the past.
>
> Thanks 73
> Paul K9OT
>

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>