I currently have an Omni V and a TS-830s. My prior rig was a Corsair
II. I have not had the chance to A/B compare the Omni V and Corsair II
so my comments are based on memories of the CII from 5 years ago.
I think the Omni is better on CW. Better selectivity and QRM fighting
features. The CII was nice but I don't recall the audio filter being
that effective. CII had only one IF filter. The Omni has the optional
9 MHz filter which helps. Mine has a 1.8 KHz filter in the 9 MHz
position and it still helps on CW receive. I can only imagine (great
song BTW) what it would be like with a 500 Hz in that slot.
The AGC circuit in the Omni is far better than the Corsair II. I recall
(correct me if I'm wrong) that the AGC in the Corsair II was
audio-derived and suffered from strong signal overload just like the
older Omni D did. Omni V has no such problems.
Now, comparing the Omni V to the TS-830s is a different story. Omni V
is the choice for CW. For SSB, my 830s is much better than the Omni V.
The VBT on the 830s does a better job of fighting QRM while retaining
intelligibility. The Omni with both 1.8 filters engaged looses more
intelligibility while not being any better at eliminating QRM. I also
find the audio section of the 830s to be quieter and with less
distortion than the Omni V.
If I had the money and space, I'd keep both and run the Omni on CW only
leaving all SSB duties to the Kenwood. Alas, the real world dictates
one will be sold and at this point the Omni will be staying (I'm mostly
CW).
- Keith -
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of OTAKEBI@aol.com
Sent: Sunday, November 20, 2005 10:46 AM
To: tentec@contesting.com
Subject: Re: [TenTec] OMNI V Question
Ed, I have an OMNI V.
It is better on SSB over the Corsair II which I also have.
I do not have any mods on mine and no upgrades.
I do not know if you can still get the chip from Ten Tec but I think
you can get the chip from the guy that made it for the company. The
keypad will change and the replacement keypad, if you can find one, is a
bear to change and I know you can't get that pad from Ten Tec.
I don't think the upgrades are worth the trouble.
If you want those up grades I would hold out for an OMNI VI+ However,
you will get a hard to fix yourself rig.
You still can't beat the Corsair II for CW.
The Corsair II is not as good as the OMNI V on SSB due to the audio and
AGC.
As you might know the OMNI V was the last of the Ten Tec easy to fix
rigs that could be completely field serviced.
Have fun,
Dan/N4VET
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|