TenTec
[Top] [All Lists]

Re: [TenTec] Fw: Your semi-annual Astron tip...

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Fw: Your semi-annual Astron tip...
From: "NZ8J" <nz8j@woh.rr.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 3 Dec 2005 16:02:10 -0500
List-post: <mailto:tentec@contesting.com>
Just another FYI..

Had a problem with my RS50M today.. started getting all sorts of RF in the
rig... I tied the negative post to the small ground lug below the neg post
on the supply.. still had RF.... took the top off.. turned the supply on...
saw an arc down by the receptacle where the ac cord plugs in.  turns out the
receptacle had a loose connection on the back of it where the 10 amp fuse
connection is  .. I temporarily soldered it.. all the RF is gone ... Will
have to order a new receptacle next week... sure doesn't take much...

Tim
NZ8J
----- Original Message -----
From: "John K Gotwals" <john@gotwals.com>
To: <tentec@contesting.com>
Sent: Saturday, December 03, 2005 3:48 PM
Subject: [TenTec] Fw: Your semi-annual Astron tip...


> I purchased a new Astron RS-35A from Ham Radio Outlook in August, 2005.
> Checks, by my Fluke 27 Multimeter and the schematic diagram dated January
> 2000, show that the negative output is not floating but is connected to
the
> ground pin of the 120 volt power cord.
>
> >Sorry, all I know about is the Astron RS-35 circa 2001.  I do not know
what
> >changes they may have made.  If you examine a schematic of that supply,
you
> >will see that if RF gets into the negative post, it goes straight to the
> >regulator circuitry.
> >
> >73, Mike N4NT
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>