To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
---|---|
Subject: | Re: [TenTec] 1254 Q-Multiplier... Yes. Add a signal strenghtmetertooand replace those 1N4148s in the 2nd Mixer! |
From: | Bwana Bob <wb2vuf@qsl.net> |
Reply-to: | wb2vuf@qsl.net,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Wed, 28 Dec 2005 19:46:11 -0500 |
List-post: | <mailto:tentec@contesting.com> |
Lee: Yes, that is another option. The AGC is not audio derived, but an audio filter would work fine. There are lots of active filter designs around. I was thinking about the Idiom Press SCAF filter. If I put it outboard, I could run it with my Scout, too. 73, Bob WB2VUF Lee A Crocker wrote: > How about an external audio based filter. I have used > several with good result. If the 1245 uses the old > ten tec audio derived AGC you could even include the > filter with in the AGC loop. If you are in a home > brew mood you could build one instead of buy one. > > 73 W9OY > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec > _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] CVS TDE headphones, Mike Gorniak |
---|---|
Next by Date: | Re: [TenTec] 1254 Q-Multiplier... Yes. Add a signal strenght metertoo and replace those 1N4148s in the 2nd Mixer!, Bwana Bob |
Previous by Thread: | [TenTec] 1254 Q-Multiplier... Yes. Add a signal strenghtmetertoo andreplace those 1N4148s in the 2nd Mixer!, Lee A Crocker |
Next by Thread: | [TenTec] CVS TDE headphones, M Schell |
Indexes: | [Date] [Thread] [Top] [All Lists] |