TenTec
[Top] [All Lists]

Re: [TenTec] openwire feed OT

To: tentec@contesting.com
Subject: Re: [TenTec] openwire feed OT
From: "James Duffer" <dufferjames@hotmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 31 Jan 2006 12:55:16 -0600
List-post: <mailto:tentec@contesting.com>


snip

>The impeadance of a dipole in free space is about 72
>ohms at the center feed point which is why you can
>feed it directly with coax.  Of course site conditions
>usually drop the dipoles impeadance quite a bit.


FWIW The impedance of free space (and a vacuumn) is approximately 377 Ohms.  
It too is referred to as Zo and is a physical quantity.  A horn antenna in 
radar or microwave serves as a match from the feedline (waveguide) and free 
space.

Jim de wd4air

>You can also feed the dipole with the higher
>impeadance open wire feeder and be ok because you are
>transfering power from a high impeadance source to a
>low impeadance load.  The key point here is that the
>antenna is the load, not another transmission line.


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>
  • Re: [TenTec] openwire feed OT, James Duffer <=