Re: [TenTec] Computer Control of OMNI VI Opt.3-Help,Suggestions Please!!

[Ken Brown <ken.d.brown@verizon.net>]

Hi Arthur,

DB25 Male plugged into Omni VI.....DB9 Female plugged into serial port of PC

Pin 3.................................................Pin 2
Pin 2.................................................Pin 3
Pin 7.................................................Pin 5

Works for me.

One diagram I have shows pins 4 and 6 on the DB9 jumpered together. I 
don't believe I had to do that.

Remember you need to go through the menus on the Omni VI to set the baud 
rate and address. The PC needs to be set up for NO parity, 8 data bits 
and 1 stop bit, according to my Omni VI manual. Check the details in 
your manual, in case the Omni VI + is different

DE N6KB



>   


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec