Lloyd:
Be sure that you have the jumper in place between the left and center
terminals as viewed from the rear of the tuner. The open wire line connects
between the outer most 2 terminals.
The rig should not be connected to antenna #4 on the tuner. It should be
connected to the SO-239 connector labeled INPUT.
Yes the Orion SWR indication is between the radio and the tuner as it should
be.
Once configured correctly it should work just fine.
73
Bob, K4TAX
----- Original Message -----
From: "LS Westbrook" <w4ao@yahoo.com>
To: <tentec@contesting.com>
Sent: Sunday, February 12, 2006 8:42 AM
Subject: [TenTec] 238 tuner + 600 ohm open wire
> Anyone using the 238 tuner with 600 ohm open wire ? I
> have my O1 w/tuner, 238 to 600 ohm, readings on the
> tuner are erratic to say the least. I can get the swr
> reading on the O1 to a decent level but I'm afraid
> that is just the match between the rig and the tuner ?
> I do have the rig connected to ant #4 on the tuner.
> Any tips would be appreciated.
>
> Lloyd W4AO
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|