Set the rolloff to 180 and the EQ to -8. Be careful with the SP.
----- Original Message -----
From: "Mark DeBord" <markinkpt@hotmail.com>
To: <tentec@contesting.com>
Sent: Monday, February 13, 2006 8:23 PM
Subject: [TenTec] V2.0 for the original Orion
> Update so far.
>
> Loaded the beta code on the original Orion. Did a master reset.
Immediately,
> the display is much dimmer and the contrast must be set to about 42. The
> sweep display works great. Mine had the hardware mod already since I
bought
> mine recently. The monitor function works better too; do not have to turn
> the af gain up when listening to my audio; matches the receive level now.
> However, the transmit audio has changed. I just recently bought the w2ihy
> boxes and had my equalization and mic gain on th Orion set to match.
> However, the mic gain must now be reduced to almost 20 with the Studio One
> (which might be good) and the TX equalization is off. Not sure what the EQ
> settings must be set to now. I used to run it at -6 db with the w2ihy
> equipment, but will have to find the sweet spot now. I think I will need
to
> re-adjust the w2ihy equipment equalization to get my audio back in line. I
> actually loaded the old software back since I did not have time to play
with
> the transmit audio tonight; will try again later. If anyone else figures
it
> out, using the Studio One, please post.
>
> Thanks,
> Mark KA4ICK
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|