TenTec
[Top] [All Lists]

Re: [TenTec] Help with New Orion II

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Help with New Orion II
From: "Chortek, Robert L" <robert.chortek@berliner.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 14 Feb 2006 16:46:41 -0800
List-post: <mailto:tentec@contesting.com>
That makes sense although I may have understated the distance between the two 
signals.

But what I don't understand is why the same problem did not also appear on the 
other radio.

73

Bob

 -----Original Message-----
From:   Carl Moreschi [mailto:n4py@arrl.net]
Sent:   Tue Feb 14 16:14:28 2006
To:     tentec
Subject:        [TenTec]  Help with New Orion II


The SSB signal has width to it and is typically 3 khz wide.  For an LSB
signal 2 khz above you, that means his signal has pieces that go as far as 1
khz below you and up to 2 khz above you.  So there is an overlap of his
signal and the JA.  The only thing filtering will do is reduce his signal so
you only hear the portion that is 500 hertz wide that overlaps your filter
width.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
> ----- Original Message ----- 
> From: "Chortek, Robert L" <robert.chortek@berliner.com>
> To: <tentec@contesting.com>
> Sent: Tuesday, February 14, 2006 2:42 PM
> Subject: [TenTec] Help with New Orion II
>
>
> > Good Morning,
> >
> > I just purchased the Orion II and must have the setting mixed up and
> > wondered if some of you experienced folks can help me straighten things
> > out.
> >
> > This morning I was listening to a JA on 80 cw (3507) who was not moving
> > the S meter.  Then, a sideband station (yes) came on 2 KHZ above the JA
> > and I could hear this garbled noise on the Orion masking the JA. I was
> > using the 600 HZ roofing filter and had the bandwidth set at 500HZ.  The
> > subreceiver audio and rf gain were both set to zero. I would not think I
> > would have been able to hear the sideband signal with the 600 Hz roofing
> > filter and bandwidth at 500 HZ.  By the way, when I listened to the same
> > thing on my FT1000D, only the JA was audible, not a whisper of the ssb
> > signal.
> >
> > I must have the settings messed up somehow.  Any suggestions?
> >
> > Thanks!
> >
> > 73,
> >
> > Bob/AA6VB
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>