You may know this but look at the boxes on the main
reciever made with red and yellow lines. The red
lines are the roofers and the yellow is the DSP
bandwidth. Did the red line show the roofer
activated? At 2Khz seperation I have have easily
removed the offending station. There was splatter on
SSB and cleaned it up quite nicely with 1800 hz
roofing filter.
John
--- "Chortek, Robert L" <robert.chortek@berliner.com>
wrote:
> Good Morning,
>
> I just purchased the Orion II and must have the
> setting mixed up and
> wondered if some of you experienced folks can help
> me straighten things
> out.
>
> This morning I was listening to a JA on 80 cw (3507)
> who was not moving
> the S meter. Then, a sideband station (yes) came on
> 2 KHZ above the JA
> and I could hear this garbled noise on the Orion
> masking the JA. I was
> using the 600 HZ roofing filter and had the
> bandwidth set at 500HZ. The
> subreceiver audio and rf gain were both set to zero.
> I would not think I
> would have been able to hear the sideband signal
> with the 600 Hz roofing
> filter and bandwidth at 500 HZ. By the way, when I
> listened to the same
> thing on my FT1000D, only the JA was audible, not a
> whisper of the ssb
> signal.
>
> I must have the settings messed up somehow. Any
> suggestions?
>
> Thanks!
>
> 73,
>
> Bob/AA6VB
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|