TenTec
[Top] [All Lists]

Re: [TenTec] blow-up number 5

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] blow-up number 5
From: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 14 Feb 2006 21:54:10 -0500
List-post: <mailto:tentec@contesting.com>
If that is the case, one might want to check that choke for continuity.

Mike

----- Original Message ----- 
From: "Larry DiGioia" <listacct@longwire.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, February 14, 2006 7:57 PM
Subject: Re: [TenTec] blow-up number 5


As several have mentioned, (Paul confirmed) there already is a "bleeder"
choke installed across the antenna terminals internally, part of an
Omni-VI Plus mod done a while back.

Mike Hyder -N4NT- wrote:

>Sometimes we would put an RFC (radio frequency choke for those of you in 
>Rio
>Linda) across the aerial inputs to the rig to get rid of DC.
>
>73, Mike N4NT
>
>----- Original Message ----- 
>From: "Larry DiGioia" <listacct@longwire.com>
>To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
>Sent: Sunday, February 12, 2006 8:57 PM
>Subject: Re: [TenTec] blow-up number 5
>
>
>The PIV is 1000V per Paul. I put a neon tester light across the end of
>the ladderline, I am going to leave it on each one for a few days and 
>watch.
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>
>


-- 
Larry  N8KU 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>