TenTec
[Top] [All Lists]

Re: [TenTec] blow-up number 5

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] blow-up number 5
From: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 14 Feb 2006 21:46:49 -0600
List-post: <mailto:tentec@contesting.com>
And, do you have a separate ground between the power supply and the radio? 
You should and thus not depend on the DC negative for ground.  Wire should 
be #10 AWG for runs of 5 ft or less.

There should be no concern for a 5KW FM at 1 mile.  AM, well that's a 
different story.

73
Bob, K4TAX


----- Original Message ----- 
From: "Larry DiGioia" <listacct@longwire.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, February 14, 2006 6:54 PM
Subject: Re: [TenTec] blow-up number 5


> There is a medium-power (5KW I think) FM station 1 mile away. I
> mentioned this to Paul, and he dismissed it.
>
> Stuart Rohre wrote:
>
>>Larry, are there any strong BC stations near you?
>>
>>I would connect a resistor of say 10,000 ohms to ground from each side of
>>the  feeder of your dipole to constantly drain static build up which is
>>common in cold dry winter weather.  Even slight wind or sway of the wires
>>could develop hundreds of volts, given the winter conditions.
>>
>>Are the leads from power supply large enough conductors and twisted all 
>>the
>>way?
>>
>>GL and 73,
>>Stuart
>>K5KVH
>>
>>
>>
>>_______________________________________________
>>TenTec mailing list
>>TenTec@contesting.com
>>http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>>
>>
>>
>
>
> -- 
> Larry  N8KU
>
> w w w . l o n g w i r e . c o m
>    100% CW     100% HF
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>