TenTec
[Top] [All Lists]

Re: [TenTec] Orion meter pegging on CW TX

To: tentec@contesting.com
Subject: Re: [TenTec] Orion meter pegging on CW TX
From: "k3hx@juno.com" <k3hx@juno.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 18 Feb 2006 20:54:37 GMT
List-post: <mailto:tentec@contesting.com>
OM,

My concern is with the initial dit or dah, the meter needle slams

against the peg and then stays there as you noted.  

73,


Tim

-- "Chortek, Robert L" <robert.chortek@berliner.com> wrote:
The needle on my Orion II goes to the peak value, whatever level that
may be depending on the power level, and holds at that peak while I
continue to xmit, without moving between dits and dahs. It is very nice.


Does yours work differently?

73,

Bob/AA6VB

Tim Wrote:  When running at indicated PWR levels above "70" the meter
needle pegs to the right when the transmitter is keyed on CW. I'd be
grateful to know of a damping technique to remedy this.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



________________________________________________________________________
Try Juno Platinum for Free! Then, only $9.95/month!
Unlimited Internet Access with 1GB of Email Storage.
Visit http://www.juno.com/value to sign up today!


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>