TenTec
[Top] [All Lists]

Re: [TenTec] re Orion speech processor

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] re Orion speech processor
From: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 22 Feb 2006 11:39:38 -0600
List-post: <mailto:tentec@contesting.com>
Mine too.  Life is too short to run QRP.

73
Bob, K4TAX

----- Original Message ----- 
From: "Rob Atkinson K5UJ" <k5uj@hotmail.com>
To: <tentec@contesting.com>
Sent: Wednesday, February 22, 2006 9:03 AM
Subject: [TenTec] re Orion speech processor


> My RF speech processor is my Centurion  :  )
>
> <<<The DSP speech processing is indeed RF and is done in software
> functionally
> after the balanced modulator but before the TX equalizer. As a result very
> impressive compression is achieved (I see average power jumping from about
> 150 watts to over 800 watts at higher settings) without any artifacts or
> distortion. I measured a deliberate audio overdrive (red LED on 
> constantly)
> and found that the junk and intermods you would expect are 60 dB down from
> full power output. Truly amazing performance. Nothing even close to this
> performance on the market.
>
> Forget any outboard speech compressor. It cannot even come close to the 
> one
> built into the Orion II.>>>
>
> And the 800 w. Orion PA sounds pretty impressive too.  :  )
>
> 73
> rob / k5uj
>
> _________________________________________________________________
> Don't just search. Find. Check out the new MSN Search!
> http://search.msn.click-url.com/go/onm00200636ave/direct/01/
>
>


--------------------------------------------------------------------------------


> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>