To: | tentec@contesting.com |
---|---|
Subject: | Re: [TenTec] TX Offset "bug" |
From: | Randy K4QO <k4qo@earthlink.net> |
Reply-to: | k4qo@earthlink.net,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Thu, 20 Apr 2006 05:48:57 -0400 |
List-post: | <mailto:tentec@contesting.com> |
>First, a friendly correction. Remember, VFOs don't have modes. Modes are >assign >to MAIN RX, SUB RX and, indirectly, to TX. It might be less confusing to post >with this in mind. >73, >Lin >WB1AIW Lin, I just read the digest after replying to a previous post - you make a good point - I should be describing the rcvr mode and not refering to the vfo. Sorry for the confusion. I still say the transmitter should follow what mode the rcvr is set to. (with no funny offset) At the end of the day, I still think this is a flaw that should be straightened out. 73, Randy K4QO _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] V2.055 bug /watch out on 60 meters!, Randy K4QO |
---|---|
Next by Date: | [TenTec] Adding an external VOX for the Model 526, Jerry Volpe |
Previous by Thread: | Re: [TenTec] Reflector is getting effective at killing sales;NOT for me, CATFISHTWO |
Next by Thread: | [TenTec] Adding an external VOX for the Model 526, Jerry Volpe |
Indexes: | [Date] [Thread] [Top] [All Lists] |