TenTec
[Top] [All Lists]

[TenTec] Orion Band Decoder Output Bug

To: <tentec@contesting.com>
Subject: [TenTec] Orion Band Decoder Output Bug
From: "Merle Bone" <merlebone@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 22 Apr 2006 10:22:00 -0500
List-post: <mailto:tentec@contesting.com>
I have been using the Orion for two years and had not noticed this issue - its 
a function of how you operate. I use the band decoder output from the Orion to 
drive a Top-Ten band decoder and two remote antenna switches. They switch 5 
antennas onto the Orion, depending on the band. In testing the issues 
associated with the "mode transfer bug," when using the Orion A>B, I noticed 
the antenna switch didn't always switch when the B VFO changed frequency. So I 
did some testing and what I observe is if the B VFO , for instance, is on 20M, 
in split-mode, the band decoder output of the Orion is switched to 20M. If you 
use the front key entry pad to put a new frequency on the A VFO, for 40M, and 
then do an A>B -  the frequency transfers to the B VFO but the band decoder 
output of the Orion does not change to 40M. It looks like the Orion band 
decoder output only changes when you use the front keypad to change bands or if 
you command the Orion remotely, from a program, to go to a new fr
 equency/band. 

I don't know if the same logic is in the V2.056 firmware - I haven't checked 
it. Someone that uses V2.056 may want to check. I'm sure the V1 code won't get 
fixed but this should go on the V2 bug list if it is the same logic in V2 - 
otherwise you can get a surprise when your amplifier starts to load the wrong 
antenna!
73,
Merle - W0EWM
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>