I saw the earlier post about the amp, but have they released any specs yet
other than the power and frequency coverage?
Ron N6AHA
----- Original Message -----
From: <CATFISHTWO@aol.com>
To: <tentec@contesting.com>
Sent: Tuesday, April 25, 2006 10:01 PM
Subject: Re: [TenTec] Elecraft KW Solid State Amps
I saw it at Visalia, and it is pretty, but I don't think it will replace
the
Alpha 87 a just yet. perhaps as a backup amp?? tom N6AJR
============================================================
In a message dated 4/25/2006 10:26:04 A.M. Pacific Daylight Time,
k4beh@juno.com writes:
Ten-Teckies,
These will be able to follow your Orion and Orion 2 so therefore it is
applicable to the T-T reflector, isn't it? Also since T-T no longer
produces a solid state amp, I thought you might be interested.
Pat-K4BEH
-------------------------------------------------------------------------
------------
The question was raised on the Elecraft reflector about the status of
their soon-to-be-introduced solid state amps. This was Eric's reply to
the query............
We officially previewed the amplifiers this weekend in our booth at the
Visalia DX convention and prior to that we were not able to answer all
of the emails we were being flooded with. (I just got back into the
office today.)
We previewed working units of the KPA800 (800W) and KPA1500 (1500W+)
solid state amplifiers at the show. We are now going through the FCC
certification process for these amps (basically to show that they can't
be used as CB amplifiers). We can not take orders until after we receive
the final certification, which usually takes 90-120 days.
The KPA 800 is a single box amplifier with an internal custom designed
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|