TenTec
[Top] [All Lists]

Re: [TenTec] question about updates

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] question about updates
From: "jack" <jfriend31@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 30 Apr 2006 13:28:25 -0600
List-post: <mailto:tentec@contesting.com>
you, Tom, are not the only original Orion owner who is happy with the radio! 
count me in twice! jack ak7o
PS i like version 1.373B3 as much as any of the previous versions. it works 
well so far as i can tell. but then i don't twiddle the knobs and push the 
buttons lots. since i run CW only, i keep the 1000Hz filter in the line to 
cut down on the noise level. now and again i switch in the 500Hz filter. 
other than volume and tuning and band changes there is not a lot to twiddle. 
usually if i can hear it i can work it! what else is there?


----- Original Message ----- 
From: <CATFISHTWO@aol.com>
To: <scm@copper.net>; <tentec@contesting.com>
Sent: Saturday, April 29, 2006 1:16 PM
Subject: Re: [TenTec] question about updates


>
> You can load in a previous version of  the software, I did it on my O  1 I
> prefer 1.372 so after it tried the ver 2 I went back to  the old one. 
> just a
> master reset, reload, and all the older versions are available on line
> somewhere.  I don't know about all the stories  being bantered about  on 
> the
> reflector, but there is a small core of very critical folks here ( 6 or 8 
> folks) who
> continually post and repost the few things that need work on the  Orion 
> and
> Orion II.
>
> If you have a question, please call the folks at Ten Tec. If I had 
> believed
> all the "information" on the Ten Tec reflector I would not have bought 
> this
> fine rig.  it works very well for me and I am amazed by its  capability. 
> the
> complaints here on the Ten Tec reflector  are mostly  about  small 
> problems
> that will most likely be fixed in future versions of  soft ware.  Its like
> buying a brand new car and complaining the ash tray is  not the right 
> size.. I love
> mine and it works very well.  Bye the way this  is the  TEN TEC reflector,
> not just the  Orion reflector..
>
> I may be one of the not so silent majority that actually enjoys the 
> Orion..
>
> tom N6AJR
>
> ==========================================================
>
> In a message dated 4/29/2006 6:58:59 A.M. Pacific Daylight Time,
> scm@copper.net writes:
>
> Are the  old versions from ten tec forever lost when you update? Can you
> reinstall say  the first version that
> came with an orion 1 on an orion 2. This may seem a  dumb question but I'm
> not computer savvy.
>
> Also I have read that the  only version with acceptable audio transmit 
> width
> for ssb with any fidelity is  the
> original orion with the first firmware - true ?
> If  all I can get with an orion 2 is firmware with severe rolloff at 
> 200Hz -
> and  nothing you can do about
> it - then I know I don't want an orion  2.
>
> 73
> Steve  wd0ct
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>