On Thu, 2006-05-11 at 04:10 -0700, W EC wrote:
> Hi everyone,I am asking for info. or help again. Does any one know a source
> to buy a roller inductor or how to repair one? My roller inductor's shaft on
> one side is loose(the metal collar that goes into the insulator) the tuner is
> a denton dtr-3000. Replies off line are ok. Thanks, Cordy @ yahoo.com
>
>
It shouldn't be hard to repair the worn bushing hole. Probably drill it
out larger and slip in a new bushing the larger OD to fit the new hole
and the right size for the shaft or maybe a bushing that bits the
outside of the existing bushing and then make the new hole in the
insulator plate large enough for that bushing. A simple repair in a
machine shop.
--
73, Jerry, K0CQ,
All content copyright Dr. Gerald N. Johnson, electrical engineer
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|