TenTec
[Top] [All Lists]

Re: [TenTec] Non-digital Ten-Tec transceivers

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Non-digital Ten-Tec transceivers
From: Tommy <aldermant@alltel.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 14 Jun 2006 19:18:24 -0400
List-post: <mailto:tentec@contesting.com>
No, it can not be answered because the filter term is incorrect. 
Neither Corsair had a 'roofing filter' other than that little Murata 
20kc wide filter right after the first mixer. Otherwise, yes, you can 
change almost all of the IF filters in the Corsair, assuming one 
knows which way to turn a screwdriver!!

Tom - W4BQF


At Wednesday 06:57 PM 6/14/2006, you wrote:
>Don't think this has been answered (?)
>
>If not, the answer is Yes.  Just pull one out and push the other in.
>
>Bob
>KB1CIW
>Corsair & Scout
>
>At 11:16 AM 6/12/2006 -0400, you wrote:
>
> >As I understand it, one of the major differences between the Corsair and
> >Corsair II is the roofing filter (4-pole vs. 6-pole). Can a Corsair be
> >retrofitted with the later filter easily or are there other circuit changes?
> >
> >Thanks,
> >
> >Craig
> >W3CRR
> >
> >_______________________________________________
>
>
>--
>No virus found in this outgoing message.
>Checked by AVG Anti-Virus.
>Version: 7.1.394 / Virus Database: 268.8.4/363 - Release Date: 6/13/2006
>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>