Keith, i have been using LOGic8 with my Orions since Dennis made it available.
i am convinced the problem with lag is due to serial ports. LOGic8 reads both
radios well but with both turned on the delay is untolerable. if i turn one of
the radios off LOGic8 speeds up to almost right on the money. however i must
click on the Freq window in LOGic8 to have the exact frequency entered
properly.
i also use MixW with LOGic8. MixW reports the frequency to LOGic8. i can find
NO way to turn that part of MixW off.
if you find a solution to your challenges please let me know. i am going to try
using a USB to Serial adapter and see if that works and eliminates the lag.
jack ak7o
-------------- Original message --------------
From: ac9s@mchsi.com
> I received my new Orion II three days ago - it has been a blast so far, but I
> have one question. I am using Logic 7 for logging and have a problem with it
> reading band / mode data when I log a qso. Logic includes a primitive rig
> control window and that displays the Orion's frequency, mode, etc just fine
> and I can control the Orion from Logic without problem. I do note that the
> frequency display in Logic lags the Orion by a little. Logic does just fine
> with the Pro that I previously used and I am using the same serial card. Any
> thoughts?
>
> Thanks --
>
> Keith - AC9S
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|