| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] (no subject) |
| From: | Ken Brown <k.brown@jach.hawaii.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 21 Jun 2006 18:37:58 -1000 (HST) |
| List-post: | <mailto:tentec@contesting.com> |
I have seen Titan 425 amplifiers both with and without plastic spacers between the plates of the loading capacitor. I have already searched the archives and not found very much info on this. When did Ten-Tec Start putting the plastic sheets in there? What kind of plastic is it? I guess polyethylene or polypropylene? -- Ken Brown N6KB _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Centaur cooling mod for lower noise?, Gary Tuck |
|---|---|
| Next by Date: | Re: [TenTec] (no subject), Ron Castro |
| Previous by Thread: | Re: [TenTec] (no subject), w8au |
| Next by Thread: | Re: [TenTec] (no subject), Ron Castro |
| Indexes: | [Date] [Thread] [Top] [All Lists] |