| To: | TenTec@contesting.com |
|---|---|
| Subject: | [TenTec] TenTec VNA printing problem |
| From: | Randy K4QO <k4qo@earthlink.net> |
| Reply-to: | k4qo@earthlink.net,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 02 Jul 2006 12:23:11 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
Assuming this site is for all things TenTec... I'm having a bit of a problem with printing the plots I get from the VNA. Basically, the plot prints fine but all the labels print as goobledeegook. (thats a special scientific term for unreadable gibberish) Anyone seen this issue and have a cure? I'm sure I'm overlooking something simple... Thanks Randy K4QO _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] More help needed on Shure 450, OTAKEBI |
|---|---|
| Next by Date: | Re: [TenTec] Shure 450 Ten Tec Setup Question, Dr. Gerald N. Johnson |
| Previous by Thread: | [TenTec] More help needed on Shure 450, OTAKEBI |
| Next by Thread: | [TenTec] FS: Shure 444 Desk Mic, PaulKB8N |
| Indexes: | [Date] [Thread] [Top] [All Lists] |