I find this talk about covers very interesting. I have a Paragon I bought
when they came out years ago. It has been a great radio and was very
expensive at the time. I always covered it. I wanted to keep it like new.
After maybe several years I noticed the paint on the rear of cabinet wearing
from taking this cover on and off. From that point I stopped covering my
radios and just clean them now and then. Maybe someday I will sell my very
nice Paragon with wear marks on the back that will look strange. Just my two
cents. The Paragon is now sitting uncovered while I run my new Jupiter.
Steve W7CM
----- Original Message -----
From: "Tod Glenn" <n7wd@cordite.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, July 12, 2006 12:38 PM
Subject: Re: [TenTec] Dust covers?
>
> On Jul 12, 2006, at 12:51 PM, ARDUJENSKI@aol.com wrote:
>
>> Right now I use towels to cover my equipment and was looking into
>> covers to
>> keep them protected and dust free. Do any of you have experience
>> with either
>> of these products?
>>
>> http://www.radiocovers.com/Ten-Tec.htm
>
>
> I bought covers from RadioCovers.com. Really nice wool felt with the
> TenTec logo sew in for about $25.
>
> ----
> Tod Glenn
> N7WD
> NAQCC #1283
> SKCC #1444
> FISTS #12134
> ARCI #12420
> n7wd@cordite.com
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|